DIY kit parts:
(1) 4"x1" circuit board with 20 patterns (15 front, 11 rear)
(2) clear cases
(16) 1.8mm LED's (4 red, 4 blue, 2 white, 6 yellow
(1) Adhesive clear shine strip for top
(1) Silver vinyl strip for top
(1) Circuit board heat shrink
(4) bolts, (12) nuts, (16) washers
(1) (1ft) red/black (power Wires)
(2) (1ft) black/black (tap control) twisted wires
(1) 4" heat shrink 3/32"
(2) Tap control buttons
(1) Slide switch
(1) 9V battery snap
(1) Operation instructions
NEW FEATURES
Continuous/cycle mode
1- 10 speed per pattern
Switch between Bright/dim mode
Enable/disable 15 minute auto off
Swap Sides mode switches the front patterns to the back and back patterns to the front
Bridge Sides mode set front patterns same as the back.
Mirror Sides mode set front patterns same as the back
You can also connect the light bar to your receiver for power if you have a 3rd channel remote.
Working with circuit boards and LED’s requires soldering experience. A temperature controlled soldering iron is required with ESD (Electrostatic Discharge) is highly recommended. Other tools (Safety First) recommended is a good pair of safety glasses, (You can find them at any hardware store.) 28AWG wire strippers, wire cutters, pliers, hobby scissors, flat tip and Phillips screwdrivers, tweezers, exacto knife, a dremel multi-tool with sanding and cutting discs, a 3/8" drill with a variation of bit sizes, a heat gun or a good hair dryer works as well.
This DIY KIT is for experienced users only!
Not responsible for damage done to the DIY KIT once it has been either partially or fully built.
If you like you may custom order, with any color choice you like. please fill out the form below after you place the order & submit below.
Other wise the default will be sent.
