1:18 Scale Vector 1 DIY KIT
20 patterns on Vector include rotators and solids
10 patterns on Traffic Advisor (LED choices available) (All Red, Blue, Yellow, Orange, ect.
DIY KIT Parts
(1) V1 Circuit Board w/ SMT
(1) CHP Light Bar Pre Hand Painted w/any color of your choice
(1) Traffic Housing
(1) Switch
(1) 9V Battery Snap
(2) Tap Control Buttons
(2) 4" Black/Black twisted pair wire for tap control buttons
(1) 6" Red/Black Power Wire
(2) 6" Black/Black Tap Wires for circuit board
(2) Black Vinyl strip for top and button
(6) Male Quick Disconnects
(6) Female Quick Disconnects
(6) Quick Disconnect Shrink Tube
(4) 1/2" Shrink Tube for tap and switch
(1) 1" Shrink tube for tap & power wires
(8) 2x5x7 Defused yellow LED's
(1) Operation instructions
Continuous/cycle mode
9 speeds per pattern
Bright/dim mode
Enable/disable 15 minute auto off
3-12V DC
Working with circuit boards and LED’s requires soldering experience. A temperature controlled soldering iron is required with ESD (Electrostatic Discharge) is highly recommended. Other tools (Safety First) recommended is a good pair of safety glasses, (You can find them at any hardware store.) 28AWG wire strippers, wire cutters, flat tip screwdrivers, sharp exacto knife, a dremel multi-tool with cutting discs, a 3/8" drill with a variation of bit sizes.
If you like you may custom order, with any color choice you like. please fill out the form below after you place the order & submit below.
Other wise the default will be sent.